Sale!

Cnc Board V3 A4988 Stepper Motor Driver Expansion Board For Arduino

 390

    • Latest Arduino CNC Shield Version 3.03
    • GRBL compatible
    • 4-Axis support
    • 2 x End stops for each axis (6 in total)
    • Spindle enable and direction

Or

Get in 2 Installments

at RS 195 per month.

With

QISSTPAY

×

All you need to apply is your debit or credit card. We only accept Visa or Mastercard.

Terms and Conditions.You can reach us on info@qisstpay.com.

SKU: 30WS-1 Category:

Cnc Board V3 A4988 Stepper Motor Driver Expansion Board For Arduino

It is an open source firmware that can run on Arduino UNO the turns G-code commands to stepper signals. It consists of PWM Spindle and direction pins, as well as 4 axis support and 2x End stops for each axis.

  • Latest Arduino CNC Shield Version 3.03
  • GRBL compatible
  • 4-Axis support
  • 2 x End stops for each axis (6 in total)
  • Spindle enable and direction

This expansion board as a driver expansion board, can be used for engraving machines, 3D printers.
It is a total of four slots, can drive four A4988 stepper motor. Each road stepper motors only need two IO ports. In other words, six IO ports can be well managed three stepper motors. Very convenient to use.
UNO for Arduino module IO port correspondence introduction.

Reviews

Be the first to review “Cnc Board V3 A4988 Stepper Motor Driver Expansion Board For Arduino”

Your email address will not be published. Required fields are marked *

Have a question? Contact us!